Insteon In-LineLinc Relay (Dual-Band) (2475SDB) Quick Star Bedienungsanleitung PDF herunterladen

Rev. 7/16/2012 12:34 PM / See Owner’s Manual for Warranty Information, Patented

*If the controller does not have a beeper, wait until its LED begins blinking

**Most products

Quick Start Guide

In-LineLinc

™

Relay (Dual-Band)

Models: 2475SDB

Installation

Note: Installation should be performed only by a qualified electrician or a

homeowner who is familiar and comfortable with electrical circuitry. If you

have any questions regarding installation, consult an electrician or call the

INSTEON Support Line at 800-762-7845.

1) Be sure to write down the INSTEON I.D. and location of the fixture

you'll be controlling (e.g., 01.F7.G5, Upstairs Bathroom Fan)

2) Turn off circuit breaker supplying power to the fixture

3) Disconnect the wires from the fixture you will be controlling and

ensure that you have ½” of bare wire on the ends

4) See Figure 1 to identify and connect the line, load, neutral and ground

wires on In-LineLinc. Be sure you have correctly identified the wires in

the junction box before connecting them.

5) After you have connected all the wires, ensure that the wire

connectors are firmly attached and that there is no exposed copper

except for the ground wire

6) Prior to reinstalling the fixture, turn on circuit breaker supplying power

to the fixture

7) Use the on/off buttons to test that the module is working and

controlling the load

8) Add In-LineLinc to a scene as a responder:

Use the On and Off button on In-LineLinc to set the load to the

state you wish to activate from the controller (turn it on if you wish

it to be on when the controller activates the scene, etc.). Press

and hold the scene controller button until it beeps.

Controller LED will blink

Press and hold In-LineLinc's Set button until it double-beeps

In-LineLinc status LED will flash once and then turn on

steady. Controller will double-beep** and its LED will stop

blinking

Confirm that scene addition was successful by tapping On then

Off on the controller's scene button

The load connected to the In-LineLinc will respond

appropriately

9) Gently place In-LineLinc into the junction box, making sure that

nothing could accidentally press any of the buttons on its face

10) Reinstall the fixture

Status

LED

On button

Off button

Set button

Figure 1

Owner’s Manual and Tech Support

Owner’s Manual and current Quick Start Guide: http://www.insteon.com/support

Call: INSTEON Support Line at 800-762-7845

This device complies with FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne doit

pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.