INSTEON 2450 Bedienungsanleitung PDF herunterladen

*Setup modes will automatically time out after 4 minutes.

Using a Sensor as an INSTEON Controller

1) Plug I/O Linc into an unswitched outlet near your sensor.

The I/O Linc Status LED should turn on.

2) Connect one sensor wire to the I/O Linc GND terminal (see Figure 1).

3) Connect the other sensor wire to the I/O Linc Sensor terminal.

4) Put your sensor in the state that will trigger an ON command from I/O Linc.

The I/O Linc Sensor Status LED should turn on if the sensor is closed or turn off it the sensor is open.

5) Set I/O Linc to linking mode* by pressing and holding the Set button until it beeps (3 seconds).

The white I/O Linc Status LED should begin blinking.

6) Press and hold the responder’s Set button for 3 seconds.

The white I/O Linc Status LED should stop blinking and turn on solid.

7) Confirm that linking was successful by tapping the Set button on I/O Linc.

The responder should respond appropriately.

Quick Start Guide

I/O Linc

™

– INSTEON

Low Voltage/Contact Closure

Interface (1 In/1 Out)

Model: 2450

Items Required

 Sensor wire: 20-22 gauge recommended

Screw

terminals

Sensor

Status

LED

Set button

Status LED

Pass-through

out

Sensor input

3.5mm

ack

Introduction

Monitor and control any low voltage devices such as contact closures,

electric door strikes and alarm sensors as part of your INSTEON home

automation network. Plus, use the built-in single-pole double-throw (SPDT)

switch to connect any low-voltage powered device for continuous or

momentary operation. Create your own remote-control door lock using a

door strike and power supply or use a security sensor to trigger INSTEON

controlled lights to turn on or off. I/O Linc acts as a repeater for all

powerline INSTEON signals, is compatible with INSTEON and X10

products and has a pass-through outlet for other AC devices.

I/O Linc Screw Terminals

5V GND Sense N/C N/O Common

5 Volts,

10mA

Ground

Sensor

input

Normally

closed

Normally

open

Switches

between

N/O and

N/C

Figure 1

Page 1 of 2

Rev. 03-15-2012

Limited Warranty – INSTEON warrants to original consumer of this product for a period of 2 years from date of purchase, this product will be free from

defects in material and workmanship and will perform in substantial conformity with its Owner's Manual. Warranty shall not apply to defects caused by

misuse or neglect.

INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845

1 2

Inhaltsverzeichnis

Seite 1 - Quick Start Guide

*Setup modes will automatically time out after 4 minutes. Using a Sensor as an INSTEON Controller

Seite 2 - Rev. 03-15-2012

Page 2 of 2 Rev. 03-15-2012 Limited Warranty – INSTEON warrants to original consumer of this product for a period of 2 years from date of purchase,

Kommentare zu diesen Handbüchern

Keine Kommentare

INSTEON 2450 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sicherheitszugriffskontrollsysteme INSTEON 2450 herunter. INSTEON 2450 User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern